Search for: All records

Single-photon avalanche diodes (SPADs) that are sensitive to photons in the Short-wave infrared and extended short-wave infrared (SWIR and eSWIR) spectra are important components for communication, ranging, and low-light level imaging. The high gain, low excess noise factor, and widely tunable bandgap of Al_xIn_1-xAs_ySb_1-yavalanche photodiodes (APDs) make them a suitable candidate for these applications. In this work, we report single-photon-counting results for a separate absorption, charge, and multiplication (SACM) Geiger-mode SPAD within a gated-quenching circuit. The single-photon avalanche probabilities surpass 80% at 80 K, corresponding with single-photon detection efficiencies of 33% and 12% at 1.55 µm and 2 µm, respectively.

 

Abstract One of the most common approaches for quenching single-photon avalanche diodes is to use a passive resistor in series with it. A drawback of this approach has been the limited recovery speed of the single-photon avalanche diodes. High resistance is needed to quench the avalanche, leading to slower recharging of the single-photon avalanche diodes depletion capacitor. We address this issue by replacing a fixed quenching resistor with a bias-dependent adaptive resistive switch. Reversible generation of metallic conduction enables switching between low and high resistance states under unipolar bias. As an example, using a Pt/Al 2 O 3 /Ag resistor with a commercial silicon single-photon avalanche diodes, we demonstrate avalanche pulse widths as small as ~30 ns, 10× smaller than a passively quenched approach, thus significantly improving the single-photon avalanche diodes frequency response. The experimental results are consistent with a model where the adaptive resistor dynamically changes its resistance during discharging and recharging the single-photon avalanche diodes. 

We report the frequency response of Al_0.3InAsSb/Al_0.7InAsSb nBn photodetectors. The 3-dB bandwidth of the devices varies from ∼ 150 MHz to ∼ 700 MHz with different device diameters and saturates with bias voltage immediately after the device turn on. A new equivalent circuit model is developed to explain the frequency behavior of nBn photodetectors. The simulated bandwidth based on the new equivalent circuit model agrees well with the bandwidth and the microwave scattering parameter measurements. The analysis reveals that the limiting factor of the bandwidth of the nBn photodetector is the large diffusion capacitance caused by the minority carrier lifetime and the device area. Additionally, the bandwidth of the nBn photodetector is barely affected by the photocurrent, which is found to be caused by the barrier structure in the nBn photodetector.